Every moisture problem has a different source. We identify yours specifically before we quote anything — then we deploy the right system, not the most expensive one.
💧
Sub-Slab Interior Drainage Installation
When hydrostatic pressure is the primary culprit, the most effective long-term solution is a properly engineered interior drainage system. We install sub-slab perforated drain tile around the perimeter of your basement — capturing water before it can rise above slab level — and route it to a sump pit equipped with a dual-pump configuration.
Our sub-slab drainage systems use schedule 40 perforated PVC pipe in a stone bed, designed to handle high-volume water tables.
📞 Get a Free Drainage Quote →
🏗️
Exterior Foundation Coating & Drainage Board Installation
Full exterior waterproofing involves exposing your foundation to the footer depth, applying a crystalline or elastomeric waterproofing membrane, installing a geocomposite drainage mat, and placing exterior drain tile at the footing — the same specification used in new commercial construction.
We use SilkOate, UMARK, and other commercial-grade membrane systems — not the paint-on damp-proofing that deteriorates within a few years.
📞 Schedule an Exterior Assessment →
🔧
Foundation Crack Injection — Polyurethane & Epoxy Systems
Poured concrete foundation cracks are repaired from the interior using high-pressure polyurethane or epoxy injection — the appropriate chemistry depends on whether the crack is actively leaking or dry. Polyurethane foam expands into wet, actively leaking cracks and cures flexible, accommodating minor future movement. Epoxy injection is used in dry cracks where structural bond restoration is the goal.
For concrete block foundation walls showing horizontal cracking or inward bowing, we pair crack repair with carbon fiber reinforcement straps anchored at the floor and rim joist.
📞 Get a Crack Injection Estimate →
🌿
Crawl Space Moisture Control: Encapsulation to Full Waterproofing
We install a minimum 20-mil reinforced poly vapor barrier over the entire crawl space floor and seal it up the walls to the sill plate — then seal all vents, install a conditioned air supply or dedicated crawl space dehumidifier, and spec a sump system if groundwater is present.
For crawl spaces with active water entry, we install a perimeter drain channel at the footer line, route it to an appropriate discharge point or sump.
📞 Schedule a Crawl Space Inspection →
⚙️
Sump Pump Installation, Replacement & Battery Backup Systems
A sump pump is only as reliable as its installation and backup plan. We install primary pumps — typically 1/2 to 3/4 HP cast iron submersibles with a minimum 10-year rating — alongside battery-operated backup systems that activate automatically when your primary pump fails or power goes out.
For finished basements and properties with high groundwater, we recommend a dual-pump system: a primary submersible at normal operating level and a pedestal backup set two inches higher.
📞 Get a Sump System Quote →
🪟
Egress Window Waterproofing & Well Cover Systems
We excavate and regrade window wells to the proper dimension, install a gravel drain bed with a perforated pipe tied into your perimeter drainage system, and apply waterproof flashing around the window frame — stopping the entry point at the source instead of managing it inside.
Window well covers are a maintenance measure, not a waterproofing solution — but paired with proper drainage installation.
📞 Book a Window Well Assessment →
